Aqua-Jet® Options/Accessories  |
Endura® Series
Endura® Series aerators offer a five-year no-maintenance warranty. This option is available on 3-150 HP Aqua-Jet® aerators. All Endura® Series are available in high efficiency, and each unit is vibration tested and hydraulically designed for optimum performance in the most stringent applications.
|
|
Aqua-Jet II® Contained Flow Aerator
The Aqua-Jet II® is designed for applications which require continued operation of aeration equipment during cold weather months, but are limited because of an inadequate heat sink due to process selection or environmental conditions. This aerator has proven to operate efficiently in a variety of applications, even in sub-zero temperatures. The dome is essentially a spray control shield mounted to the diffusion head of the Aqua-Jet aerator.
|
|
| |
Anti-erosion Assemblies
Anti-erosion assemblies consist of a stainless steel plate attached to the bottom of the Aqua-Jet intake cone via an anti-vortex cross. The assembly causes water to be drawn from the sides of the intake cone, rather than from directly below it; and prevents the floor erosion that can sometimes occur in shallow basins. Anti-erosion assemblies are available for all HP Aqua-Jets. Consult your Aqua-Aerobic representative or the factory for dimensions.
|
|
Draft Tubes
The Draft Tube accessory provides an extension of the intake cone and permits a deeper intake of water. The draft tube extension is available in lengths of three and six feet.
|
 |
Aqua-Jet II® Options/Accessories
|
Endura® Series
The Endura Series is sure to set a new industry standard. It's the same quality product manufactured by Aqua-Aerobic for more than 32 years, with one difference - it's better. You'll realize all of the benefits and cost savings associated with the Endura Series following the installation of these products into your wastewater application. |
|
| |
AquaDDM® Options/Accessories
|
Directional Flow Assembly
The AquaDDM® is available with an optional directional discharge assembly which converts the downward vertical flow to a horizontal flow.The AquaDDM® with a directional flow assembly is ideally suited for use in long narrow tanks and oxidation ditches where directional flow may be necessary or desirable. In such applications, the AquaDDM® with a directional flow assembly greatly reduces or eliminates short circuiting of the basin, eliminates dead spots and provides exceptional mixing of the basin contents.
|
|
Anti-Erosion Plate
Aqua-Aerobic Systems has designed an anti-erosion plate for use in those applications which the AquaDDM® is installed in earthen basins. Our unique patented installation procedure allows the anti-erosion plate to be easily installed without dewatering the basin.With the use of a float mounted winch, the anti-erosion plate is suspended from the float of the AquaDDM® directly below the discharge volute. The mixer and plate are then towed into position and lowered, as one, into the basin. |
 |
Endura® Series
The Endura Series is sure to set a new industry standard. It's the same quality product manufactured by Aqua-Aerobic for more than 32 years, with one difference - it's better. You'll realize all of the benefits and cost savings associated with the Endura Series following the installation of these products into your wastewater application. |
|
ThermoFlo® Options/Accessories
|
Endura® Series
The Endura Series is sure to set a new industry standard. It's the same quality product manufactured by Aqua-Aerobic for more than 32 years, with one difference - it's better. You'll realize all of the benefits and cost savings associated with the Endura Series following the installation of these products into your wastewater application. |
|
| |
|
